Manual DP-TR10

Installation Video

Instructions (Full Version)

Installation Steps In Picture 

*For your convenience and safety, please read the warning part in the full version before starting Installation

Fix the steering lever.
  • Insert the steering lever into the body hole.
  • Insert the Φ10 washer on the steering lever.
  • After the steering lever is installed in place, insert the cotter pin to bend and fix it.
Fix the rear axle.
  • Insert the rear axle into the car.
Fix the gear box(L/R)
  • Put the gear box into the rear axle and clip the motor and motoe wire into the body slot.

  • Put the gasket, front wheel, gasket and nut into the front axle in turn.
  • Fix the nut with the M10 wrench and then attach the front wheel cover to the wheel.

  • Place the rear wheel, gaskets, and nut on the rear axle in turn.
  • Fix the nut with the M10 wrench and then attach the rear wheel cover to the wheel.
  • Clip the body connection into the body and fix it with M4*10mm screws.
Put the vehicle upside down.
  • Find out the main power line under the seat, insert the plug-in of the power line into the corresponding socket of the receiver.
  • Connect one end of the right drive motor line with the left drive motor line.
  • Insert the other plug-in into the socket of the receiver. 
Fix the steering wheel.
  • Remove the nut and bolt from the steering wheel.
  • Connect the wires coming from the steering column to the wires on the steering wheel.
  • Insert the steering wheel over the steering and secure with nut and bolt.
    Fix the seat
    • Merge seat.
    • Clip the seat into the body.
    • Rotate the latch on the seat to secure the seat.
    Fix the tailstock.
    • Clip the tailstock into the body slot.
    Fix the chimney.
    • Clip chimney into the body slot.
    Fix the rear bucket wheel and rear bucket wheel cover.
    • Put the gaskets, bucket wheel, gaskets and nut into the car bucket axle in turn.
    • Fix the nut with the M10 wrench and then attach the bucket wheel cover to the bucket wheel.
    Fix the car bucket connection.
    • Clip the car bucket connection into the car bucket and fix it with M4*10mm screw.
    Fix the car bucket axle fixed seat.
    • Clip the car bucket axle fixed seat into the car bucket and fix it with M4*10mm screw.
    Fix the car bucket axle.
    • Clip the car bucket axle into the car bucket axle fixed seat and fix it with M4*20mm screw.
    Fix the car bucket latch.
    • Connect the vehicle body with the car bucket, clip it into the car bucket latch, rotate the car bucket latch fix it.