Manual ATV BW-A20

 

Installation Video

Instructions (Full Version)

Installation Steps In Picture 

Installation instruction of ATV

*For your convenience and safety, please read the warning part in the full version before starting Installation

Fix the dashboard

  • Clip the dashboard into the body.
  • Fix with M4*12mm screws.
Fix the central control
  • Take the center control out of the body hole.
  • Use scissors to cut the tie for fixing the harness.
  • Clip the central control into the body slot as shown in the figure.

 Fix the front bumper.

 Fix the front bumper (D):

  • Clip the front bumper (D) into the car body.
  • Fix with the screws (1).
Fix the steering lever
  • Take Φ10 insert the washer into the steering lever.
  • Clip the steering lever into the body.
Fix the square tube
    • Clip the square tube into the body.
    • Fix with M4*12mm screws.
    Fix the four drive front support.Fix the four drive front support (I):
    • Insert the bearing (5) into the four drive front support.
    • Insert the four drive front support into the body square tube.
    Fix the four drive front support.Fix the four drive front support:
    • In turn put the Φ10 washer (4) and the nut (3) into the dual drive front bracket.
    • Fix the nut with the M10 wrench.
    Connect the motor wires.
    Connect the motor wires as shown in the figure.
    Fix the rear axle.
    Insert the rear axle into the car.
     
    Fix the gear box.
    Put the drive motor into the rear axle, and stuck the motor into the body slot. (Tips: gear box left right distinction)
    Fix the front wheels and the rear wheels.
    Fix the front wheels and the rear wheels as shown in the figure.
     
     
    Fix the steering wheel.
    Fix the steering wheel:
    • Remove the nut and bolt from the steering wheel.
    • Insert the steering wheel over the steering and secure with nut and bolt.

    Please connect the wires under the car seat.
     
    Fix the seat.
    Fix the seat (H):
    • Clip the seat into the car body.
    • Rotate the latch on the seat to secure the seat.
      Fix the backrest.
      Clip the backrest into the car body.