Manual UTV BW-U20Pro
Installation Video
Instructions (Full Version)
Installation Steps In Picture
*For your convenience and safety, please read the warning part in the full version before starting Installation.
Fix the dual drive front support (N):
- Insert the spring and spring sleeve into the dual drive front support.
- Insert the dual drive front bracket into the body square tube.
Fix the dual drive front support:
- In turn put the Φ10 washer (4) and nut (3) into the dual drive front bracket.
- Fix the nut with the M10 wrench.
- Insert the front bumper (D) into the car body.
- Fix with screws (1).
-
Remove the nut and bolt from the steering wheel;
-
Connect the wires coming from the steeing column to the wires on the steering wheel ;
-
Insert the steering wheel over the steering and secure with nut and bolt.
- Clip the tail wing into the car body.
- Connect the light line in the front bar with the light line on the car body.
- Clip the front bar into the car body.
- Clip the rear bar into the car body.
- Clip the seat into the car body.
- Rotate the latch on the seat to secure the seat.