Manuel Truck BW-T09L

Installation Video

Instructions (Full Version)

Installation Steps In Picture 

*For your convenience and safety, please read the warning part in the full version before starting Installation

Clip front fender(L/R) into the body(Note: front fender distinguish left and right).

Turn over the car body and fix with M4*12 screw.

Insert the front bracket assembly into the body square tube.

In turn put the Φ10 gaskets and nut into the dual drive front bracket, fix the nut with M10 wrench.

As shown in the figure: Connect the motor wires.

Insert the steering lever into the steering motor hole.

Turn the car body over so that it faces up.

Insert Φ10 gaskets on the steering lever.

After the steering lever is installed in place, insert the cotter pin to bend and fix it.

Stuck the front bumper into the car.

Fix with M4*12 screw.

Fix with M4*14 screw.

Insert the rear axle into the car.

Clip the rear bumper into the body.

Fix with M4*12 screw.

Clip rear support into the body.

Fix with M4*12 screw.

Clip Rear fender(L/R) into the body(Note: Rear fender distinguish left and right).

Turn over the car body and fix with M4*12 screw.

Clip seat support into the body.

Fix with M4*12 screw.

Put the front wheel, gaskets and nut into the front axle in turn.

Fix the nut with the M10 wrench and then attach the wheel cover to the wheel.

Place the gear box, rear wheel, gaskets, and nut on the rear axle in turn.

Fix the nut with the M10 wrench and then attach the wheel cover to the wheel.

Put the drive motor into the rear axle and stuck the motor into the body slot.

Then connect the connectors coming from the gear box to the wire connector coming from the battery.

Use a screwdriver to remove the searchlight battery cover screws and install them in sequence.

  • Put the battery into the battery card slot after distinguishing the positive and negative poles.
  • Cover the battery cover and fix it with screws.
  • Power switch: (-)=on, (o)=off.
*This product does not provide dry batteries.
Put the car upside down.
①&②: Find the rear motor plugs(L/R) and connect them to the plug on the receiver respectively(the plug on the receiver is not differentiated between left and right).
③: Find the main power cord plug of the battery and insert it into the corresponding socket of the receiver.
Clip the decorative lamp into the front fender of the body.
Attach the steeing wheel.
  • Remove the nut and bolt from the steering wheel.
  • Connect the wires coming from the steering column to the wires on the steering wheel.
  • Insert the steering wheel over the steering and secure with nut and bolt.
Fix the mirror(L/R)
  • Stuck the mirror into the car.
Fix the search light.
  • Butt and fix the stailstock with the searchlight. Use M4*12 screws to fix the inside of the two butted brackets and snap them into the car.
Fix the windshield.
  • Stuck the windshield into the corresponding slot on the body.
Fix the seat.
  • Insert the upper seat cover into the lower seat cover.
  • Stuck the seat buckle into the vehicle slot.
  • Fix with screws.