Manuel UTV DP-U20C

Installation Video

Instructions (Full Version)

Installation Steps In Picture 

*For your convenience and safety, please read the warning part in the full version before starting Installation.

Fix the four drive front support.

Fix the dual drive front support:

  • Insert spring and spring sleeve into the dual drive front support.
  • Insert the dual drive front support into the body square tube.

 

 Fix the dual drive front support:

  • In turn put the Φ10 washer and nut into the dual drive front bracket.
  • Fix the nut with the M10 iron wrench.
Fix the Tail lamp decoration
  • Clip the tail light trim into the body slot.
Fix the rear axle
  • Insert the rear axle into the car(or remove the rear axle pressing block with a screwdriver, put the rear axle into the clamping slot, and then fix the rear axle pressing block with a screwdriver).
Fix the gear box(L/R)
  • Put the gear box into the rear axle, and stuck the motor into the body slot. (Tips: gear box left right distinction)

    Fix the front bumper
    • Clip the front bumper into the front bumper base.
    • Fix with screws.
    Fix the front bumper:
    • Insert the front bumper into the car body.
    • Fix with screws.
    • Put the gasket, front wheel, gasket and nut into the front axle in turn.
    • Fix the nut with the M10 wrench and then attach the wheel cover to the wheel.
    • Place the rear wheel, gasket, and nut on the rear axle in turn.
    • Fix the nut with the M10 wrench and then attach the wheel cover to the wheel.
    Put the car upside down.
    • ①&②: Find the rear motor plugs(L/R), and connect them to the plug on the receiver respectively(the plug on the receiver is not differentiated between left and right).
    • ③: Find the main power cord plug of the battery and insert it into the corresponding socket of the receiver.
    Fix the steering wheel:

    • Remove the nut and bolt from the steering wheel;

    • Connect the wires coming from the steeing column to the wires on the steering wheel ;

    • Insert the steering wheel over the steering and secure with nut and bolt.

    Fix the tail:
    • Clip the tail wing into the car body.
    Fix the front bar:
    • Connect the light line in the front bar with the light line on the car body.
    • Clip the front bar into the car body.
    Fix the rear bar:
    • Clip the rear bar into the car body.
    Secure the net bag to the rear bar.
    Fix the seat:
    • Clip the seat into the car body.
    • Rotate the latch on the seat to secure the seat.